McIntosh C500C Instrukcja Właściciela Pobierz pdf (Strona 28)

How to Operate the C500

Power On

The Red LED above the STANDBY/ON push-button lights

to indicate the C500 is in Standby mode and is connected to

a live AC Outlet. To switch On the C500, press the

STANDBY/ON push-button. Refer to figure 64. The Al-

phanumeric Display will indicate the last input listened to.

If this is the first time the C500 is switched on, the display

will indicate “15 TUNER”, refer to figure 61.

Notes: 1. Dependent upon which Preamplifier (C500P or

C500T) is connected to the C500C the Front

Panel Alphanumeric Display will indicate

different operational messages when switched

On, refer to page 32 for additional information.

2. With the C500 Tube Preamplifier connected to

the C500C, the first display on the

Alphanumeric Numeric will be “TUBE

WARMUP”. Refer to figure 63. The amount of

time the display will indicate “TUBE

WARMUP” is dependent upon the temperature

of the Tubes inside the C500T.

Balance Control

Adjust the BALANCE control as needed to achieve ap-

proximately equal listening volume levels in each loud-

speaker. Turn the BALANCE to the Left to emphasize the

left channel by reducing the level of the right channel. Turn

the BALANCE to the right to emphasize the right channel

by reducing the level of the left channel.

As soon as the BALANCE control is turned, the Volume

Display reads the balance change from 1 to 107 in one dB

steps. Refer to figure 65. After approximately 3 seconds the

Volume Display returns to the Volume reading. To verify the

balance setting without changing it, move the control one

detent in either direction. The display will indicate the se-

lected balance changes for approximately 3 seconds and

then return to the volume display.

The “L” or “R” will illuminate to indicate which channel

has been emphasized by the BALANCE control. It is per-

fectly normal for the BALANCE control to be off the center

to achieve the correct listening volume from each loud-

speaker in many listening rooms. Listening balance can also

vary with different program sources, room acoustics and

listening positions relative to the loudspeakers.

Source Selection

Select the desired Listening Source with the Front Panel

LISTEN Control or the appropriate Push-Button(s) on the

Remote Control. In a similar manner, select the Record Out-

put Source with the Front Panel RECORD Control. When

the RECORD Control is rotated, the Front Panel Alphanu-

meric Display will change to indicate the Title of the Record

Input on the left side, the volume level in the center and the

Title of the Listen Input on the right side. Both Titles will be

the short text form and the display will revert back to the

regular display in about six seconds after the rotation of the

Figure 65

Figure 64

Figure 63

Figure 61

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

McIntosh C500C Instrukcja Właściciela Strona 28

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Wzmacniacze audio McIntosh C500C